Yükleniyor
Yükleniyor
Services
Turning, milling, 5-axis, prototype, and serial production run under the same discipline. A service is not a machine list — it is how the part closes.
01
We hold the rotating part on a single axis.
Diameter steps, concentricity, and face surfaces close in the same setup on shafts, bushings, and flanges. Grinding-bound work receives deliberate stock allowance.
Problem solvedDiameter drift after re-clamping and uncontrolled grinding allowance.
02
Prismatic bodies are resolved on the plate.
Flatness and positional tolerance in pockets, covers, and clamping surfaces are maintained through operation sequence. Unnecessary second stations are not opened.
Problem solvedMulti-face parts shifting on every setup and scattered pocket / thread work.
03
We close angled surfaces without re-fixturing.
Multi-angle geometries are machined in a single setup. The goal is not to showcase the machine — it is to cut deviation with short tools and collision-controlled toolpaths.
Problem solvedPositional tolerance opening across sequential setups and re-clamping loss.
04
The first part comes out in serial material.
Samples are produced for assembly and measurement. Not an approximate mock-up — workholding and tooling strategy that can carry to serial.
Problem solvedTolerance and grip remaining on the drawing only before serial release.
05
When the approved card locks, the batch grows.
Tool life, in-process checks, and shipment window run on the same plan. Station sequence does not change on repeat orders.
Problem solvedDimensional drift as the batch grows and untracked station deviation.
Approach
When the file arrives, we first discuss which surface closes in a single setup. Quality is not a separate package — it is the delivery condition for every service. Technical capabilities explain machine and material range separately.
Technical capabilitiesIndustries
Process
01
Drawing, material, tolerance, and quantity are clarified.
02
Turning, milling, or 5-axis; workholding is written down.
03
Serial does not open until dimensions and assembly are verified.
04
The batch closes with measurement records and documentation.
If part geometry and quantity are clear, we lock in turning, milling, 5-axis, prototype, or serial from the start.
